Leave Your Message
Screening 10k+ Headphones in 30 Mins: Non-Destructive Battery Testing with DP-09D
Case Study
Case Studies

Screening 10k+ Headphones in 30 Mins: Non-Destructive Battery Testing with DP-09D

Background and Challenges

During the manufacturing process of lithium-ion batteries, due to fluctuations in the winding process or equipment failures (such as abnormalities in the winding machine), some defective products with potential safety hazards may pass the routine quality inspection and enter the subsequent stages. These defective batteries often perform normally during short-term usage tests and are difficult to be detected by traditional methods, but they pose risks of overheating, combustion, and even explosion in the long term.

Recently, a Bluetooth headset manufacturer discovered that a batch of packaged products had mixed in such high-risk batteries just before shipment. Due to the large quantity of this batch (approximately 10,000 units) and the tight shipping schedule, if traditional disassembly testing or one-by-one replacement methods were adopted, it would cause severe delivery delays. Therefore, an non-destructive and highly efficient screening method is urgently needed to accurately eliminate the problem products before shipment.
​

Technical Principle and Difference Analysis

After in-depth communication with the customer and technical verification, it was confirmed that there is no difference in appearance between defective batteries and normal batteries. However, there are significant differences in thermal properties:

• Normal battery: During charging, the surface temperature does not exceed 40℃ at its maximum.

• Defective battery: Due to abnormal internal resistance, the surface temperature rapidly rises to around 50℃ after half an hour of charging.

Based on this significant temperature difference characteristic (ΔT ≥ 10℃), we decided to use the DP-09D infrared thermal imager for visual batch screening.

Solution and Implementation Process

To achieve rapid and accurate screening, we have developed the following standardized operation procedures for our clients using the DP-09D:

Batch charging preparation: Purchase and deploy multi-port USB charging devices, build a high-density charging array to support the simultaneous charging of a large number of headphones.

Thermal imager parameter settings:

Enable high-temperature tracking: Activate the device's automatic high-temperature tracking function to ensure the screen locks onto the highest temperature point in real time.

Set temperature rise alarm: Set the alarm threshold at 45°C. This threshold lies between the normal temperature (≤40°C) and the abnormal temperature (≥50°C), leaving sufficient safety margin.

Job execution:

Charge the headphones uniformly, with the charging duration controlled at 30 minutes.

Use the thermal imager to scan the charging area.

Abnormal determination and handling:

When a heat source exceeding 45°C appears in the image, the edge of the thermal imager screen will flash a warning, and the buzzer will simultaneously alarm.

The high-temperature tracking icon will directly indicate the specific location of the faulty device.

Operators, based on the sound and light alarms and the thermal imaging indications, quickly isolate the abnormal headphones.Implementation Results

Overview of Core Data

By adopting the DP-09D infrared thermal imaging screening solution, the customer successfully completed the full inspection of the entire batch of products within a short period of time:

10,000+ units

Full non-destructive screening, covering all the shipped products in the batch

30 minutes

Single charging screening cycle, significantly reducing the inspection time

45℃

Intelligent temperature rise alarm threshold, accurately identifying abnormal heat sources

• Efficiency improvement: Achieved non-contact and visual rapid screening, significantly shortening the inspection cycle.

• Risk avoidance: Precisely eliminated all potential hidden defect products, ensuring the safety of the shipped products.

• Delivery guarantee: Qualified products arrived on schedule, only a small number of defective products were re-supplied, minimizing commercial losses.

The DP-09D infrared thermal imager can provide customized inspection solutions. Does your production line also face similar hidden defect problems? Contact us to obtain customized thermal imaging inspection solutions."


2026-05-13